Routing Insert Effects and Individual Outputs - Triton Keyboards

The Triton's HI synthesis allows for very simple routing of sounds to any of the 6 outputs in the sequencer mode.  In addition, you can choose whether sounds are routed dry or with insert effects.  This tutorial will discuss both processes. Please take the time to read both, as the first section will provide insight for the second.

Tutorial 1 - Assigning Non-Effected (Dry) signals to individual outs

1.       Press the SEQ button to enter Sequence Mode.

2.       Press the MENU button.

3.       Touch “P8-Insert Effect” on the screen.

4.       You should be on a screen that reads "Effect RoutingT01-08" at the top of the screen.  If not, touch the “Routing 1-8” tab on the bottom of the screen.

On this screen, you'll notice that the first 8 tracks of the sequence are listed, each track is defaulted to "L/R", which means that each track is set to output to the stereo Left and Right jacks on the back of the unit.  This can be changed for each track.  We'll use track 1 for our example:

5.       Under the “IFX/Indiv. Output select BUS”  parameter, Touch the arrow next to ">L/R" for track 1.  A screen will appear with various choices.

6.       On the right side of the menu, you can touch 1, 2, 3, 4, 1/2, 3/4 to route your tracks to that output/pair of outputs. (1 for output 1, 2 for output 2, 3 for output 3, etc…)

7.      Repeat for track 2-16 as needed.

Note: You can continue on to tracks 9-16 by touching the "Routing 9-16" tab at the bottom of the screen.

Tutorial 2 - Assigning tracks to individual outs with Insert Effects

Insert effects are effects that can be assigned to specified tracks.  Much like our previous example, insert effects can be set to output whatever signal is routed to them to individual outs. 

First, let’s get an insert effect assigned in the Sequencer mode:

1.       Press the SEQ, button to enter the Sequencer Mode.

2.       Touch “P8-Insert Effect” on the screen.

3.       Touch the "Insert FX" tab at the bottom of the screen.  This is where you can assign up to 5 insert effects which the 16 tracks can be routed to taste. 

4.       Using the value slider, buttons or dial, select an effect of your choice for "IFX1".

5.       Touch the "Off" tab so that it says "On".

To the right, you'll notice a box that says "L/R"; very similar to the one in the first tutorial. This is the individual assign for the effect.   So, any track that is routed to it will subsequently come out of the output you've specified, with the selected effect.

6.       Under "Bus. Sel.", Touch the arrow next to ">L/R" for IFX1.  A screen will appear with various choices.

7.       You can touch 1, 2, 3, 4, 1/2, 3/4 to route your tracks to that output/pair of outputs. (1 for output 1, 2 for output 2, 3 for output 3, etc…)

Now, we can set tracks to use that effect and come out of the selected output. Again, let's use track 1 as our example:

8.       On the bottom of the Screen, Touch the “Routing 1-8” tab.

9.       Under the “IFX/Indiv. Output select BUS”  parameter, Touch the arrow next to ">L/R" for track 1.  A screen will appear with various choices.

10.   Select “IFX 1” as the insert effect bus you route to.

Track 1 is now routed to IFX1, which is set to come out of the output you selected for step 8.